13
Operations
ENGLISH
LISTENING TO A PROGRAM SOURCE
Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button
lights up.
This means that the receiver is not
disconnected from the AC mains and
a small amount of current is retained to support the
operation readiness.
• To switch the power off, push the POWER switch
again.
• Then the power is cut off and the POWER ON/
STANDBY button goes off.
• Each time the POWER ON/STANDBY button on the
front panel is pressed, the receiver is turned on to
enter the operating mode or off to enter the standby
mode.
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the receiver is turned on
automatically and the desired input is selected.
• Then the SPEAKER indicator lights up and the
sound can be heard from the speakers connected
to the speaker terminals.
• When using the headphone for private listening,
press the SPEAKER button again to switch the
speakers off.
• Each time the “VIDEO” button on the front panel is
pressed, the input source changes as follows:
VIDEO 1 VIDEO 2 VIDEO 3
• Each time the “AUDIO” button on the front panel is
pressed, the input source changes as follows:
CD AUX1 AUX 2 TAPE
• Each time the “FM/AM” button is pressed, the band
changes as follows:
FM ST FM MONO AM MONO
When selecting the EXTERNAL IN as desired,
• "EXT IN" is displayed and 6 separate analog
signals from the component connected to this input
pass through the tone and volume circuits only and
can be heard from your speakers.
• Select the desired input source to cancel the
external in function.
• These analog signals can be heard only, not
recorded.
1. In the standby mode, turn the power on.
2
. Switch the speakers on.
3. Select the desired input source.
Note :
• Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup
precedures. (For details, refer to "System Setup" on page 29.)
