ENGLISH
38
SETTING THE CH LEVEL
Note :
• Depending on the speaker settings ("N (None or No)"), some channels cannot be selected.
• The LFE level can be adjusted within the range of
-10 ~ 0 dB and other channel levels within the
range of -15 ~ +15 dB
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower setting
as necessary.
1
. Press the CURSOR UP()/DOWN() buttons to select the desired channel.
2. Press the CURSOR LEFT()/RIGHT() buttons to adjust the level of the selected channel or
program source's LFE as desired.
3. Repeat the above steps 1 and 2 to adjust each channel level.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory("CAL"), not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 19.)
Adjusting the current channel level
Example) When selecting Dolby Digital source's LFE
