DART 300 Migration Guide Comparative AT Command Reference
2110291 Rev 1.0 Page 28
Table 4-5: AT [^] Commands (continued)
Command DART 200 DART 300 Equivalent
^L
LASI and WASI Set
Sets the LASI/WASI value into one of the 10
slots in the DART’s table.
LASI and WASI Set
Not supported.
^P
Personalization Mode
This command must be issued before any other
Service Provider commands can be executed.
Personalization Mode
Not supported.
^S
SLIP Address Set
Sets the SLIP IP Address of the Modem. This
internal address is a private address between
the modem and the terminal connected to the
serial port and is unknown to the network.
SLIP Address Set
Not supported.
The Minus (-) command set is only available on the DART 200. The DART 300 uses alternative
commands or registers where equivalent functions exist.
Table 4-6: AT [-] Commands
Command DART 200 DART 300 Equivalent
-L
Lock Specific Channel
Override normal Radio Resource Management
functions and lock onto a specific channel.
Set Modem Channel
Channel locking and scanning is controlled
with +WPCHAN.
-L<n> = +WPCHAN=<n>
-L- = +WPCHAN=0 (unlock)
-R
Reboot
Restarts the DART 200.
Reset
The DART 300 is reset with +WVRESET.
-V
View Radio Source Management Data
Displays the current value of pertinent Radio
Resource Management Data. See the
DART 200 User Guide for details.
View Radio Source Management Data
Not supported.
-Z
Display Current Authentication Credentials
Shows the current values for the ASN
(sequential) and ARN (random) authentication
numbers.
Display Current Authentication Credentials
Not supported.
