A SERVICE OF

logo

Open as PDF
next previous
Troubleshooting . . . continued
Was the entire bar code scanned?
* Drag the BCR through the entire bar code at a constant speed.
Increase the scanning speed. Typically the BCR is moved too
slowly.
* Be sure the BCR scans the entire bar code.
* Be sure the BCR maintained contact with the surface of the bar
code.
* Be sure the bar code is not damaged, dirty or worn. Try to scan an
area without these defects.
Does the SP78-200 BCR tip need replacement?
If the tip becomes damaged or shows signs of excessive wear, it must
be replaced.
To replace the tip:
1) Disconnect the BCR from the instrument.
2) Unscrew the tip from the wand.
3) Replace using part number SE124-01-01.
9-4