Filter
Top Products
Technical Reference
72 56K Voice Faxmodem Internal - User’s Guide
Fax Commands
+FCLASS=n Sets the mode of operation
FCLASS=0 Data mode
FCLASS=1 Group 3 Facsimile Service Class 1
mode
FCLASS? Displays the current FCLASS mode
(See mode descriptions above)
+FCLASS=? Displays the FCLASS mode options
(See mode descriptions above)
+FTS=n Stops the fax transmission. Then the modem waits for
a specified time before OK appears on screen. The
pause is set in 10 millisecond intervals. n is the number
of 10 millisecond intervals that pass before OK appears.
(n=0-255)
+FRS=n Makes the modem wait for a specified length of silence
before sending OK to the screen. The pause is set in10
millisecond intervals. n is the number of 10 millisecond
intervals that pass before OK appears.(n=0-255)
Note: This command terminates with OK when either
the specified amount of silence is detected or when the
user types anything (which is ignored).
+FTM=n Transmits data using the modulation specified by
n.(n = 3, 24, 48, 72, 96, 97, 98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the end of
this section for an explanation of messages that appear
in response to this command.
+FRM=n Receives data using the modulation specified by
n.(n = 3, 24, 48, 72, 96, 97, 98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the end of
this section for an explanation of messages that
appear in response to this command.