Filter
Top Products
18 C
HAPTER
1: I
NTRODUCING THE
S
UPER
S
TACK
3S
WITCH
4400
Default Settings Table 6 shows the default settings for the Switch 4400:
Ta b le 6
Default Settings
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize
in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
■
IP Address
■
Subnet Mask
■
Default Router
Feature Switch 4400
Automatic IP Configuration Enabled
Port Status Enabled
Port Speed 10/100 Mbps ports are auto-negotiated
Duplex Mode All fixed 10BASE-T and 100BASE-TX ports are
auto-negotiated
Flow Control
■
Enabled in half duplex
■
Auto-negotiated in full duplex
Broadcast Storm Control Enabled
Virtual LANs (VLANs) All ports belong to the untagged Default VLAN
(VLAN 1) with 802.1Q learning operational
IP Multicast Filtering Filtering enabled
Rapid Spanning Tree Protocol Enabled
Fast Start:
■
Enabled on front panel ports
■
Disabled on rear panel port
RMON Alarm Enabled
Smart Auto-Sensing Enabled
Webcache Support Disabled
Quality of Service (QoS) All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to “best effort” for all other traffic.
17204ua.book Page 18 Monday, August 13, 2001 11:28 AM