Filter
Top Products
Unpacking a Chassis 9
3 By the time you read these instructions, you will have already opened the
shipping box. If you followed the instructions that are printed on the
outside of the shipping box, you turned the box 90 degrees from its
shipment position before you opened it. This position allows you to easily
pull and slide the contents out of the box laterally, rather than to lift them
vertically out of the box.
4 When you first opened the box, you should have seen:
■ The chassis wrapped in a plastic bag.
The chassis is held securely in place by foam supports on two sides
and it is protected from dust and scratches by a plastic bag. One side
of the chassis will be facing you.
■ The cardboard accessories tray located on top of the chassis.
5 Pull the accessories tray out of the shipping box.
6 Verify that the following items are included in the accessories tray:
■ One power cord that is appropriate for your country.
■ One hardware kit in a plastic bag that contains:
■ Two rack-mount flanges
■ Fourteen screws
■ Four rubber feet
■ One cable management device
■ Fourteen plastic ties
■ One standard null modem RS-232 console cable
■ Three printed manuals:
■ Switch 4005 Key Information Guide (this guide)
■ Switch 4005 Installation and Maintenance Guide
■ Switch 4005 Software Configuration Guide
7 Grasp the top and bottom of the chassis and slide it laterally out of the
box. The foam supports should stay attached to the chassis.
8 Remove the foam supports and unwrap the plastic bag from the chassis,
taking care not to damage any components (such as modules) that are
preinstalled in the chassis.
CAUTION: Do not grasp any part of the preinstalled modules when you
remove the foam supports or plastic bag from the chassis, because you
may damage them.