Filter
Top Products
3 - 18 ONline Ethernet 10BASE-FB Module Installation and Operation Guide
The 10BASE-FB Module-Switching Module can be set to high or normal
power through the dip switches (see Table 3-4).
Saving Module Configuration
To save the module and port settings to management module memory, use
the following command:
SAVE MODULE_PORT
Showing Module Configuration
You can display status information about the 10BASE-FB Modules using the
following commands:
❑ SHOW MODULE
❑ SHOW MODULE VERBOSE
❑ SHOW PORT
❑ SHOW PORT VERBOSE
For example, the following command displays detailed information about
port 1 on the Port-Switching 10BASE-FB Module in slot 8 of the
concentrator.
ONline> show port 8.1 verbose [ENTER]
Port Display for Module 5104M-FBP:
Port Mode Status Network General Information
_____________________________________________________________
08.01 ENABLED OKAY ETHERNET_2
Network Dip Setting: ETHERNET_2
Mode Dip Setting: ENABLED
Low Light Warning: ENABLED
Low Light Warning Dip Setting: ENABLED
High Power Optics: ENABLED
High Power Optics Dip Setting: DISABLED