Filter
Top Products
DK8X Motherboard
Step 12
Step 13
The spring clip must be installed as shown.
1. Make sure the retention clip is aligned with
the plastic lug on the retention frame.
2. Carefully push straight down on the clip.
This may take more force than the first side.
Step 15
Step 14
Connect the fan power lead to the proper connector to the motherboard.
Ensure the cam lever is locked into the retention frame.
Carefully turn the cam lever to lock into place.
Check the installation completely to make sure heatsink is installed correctly before starting the system. When the system
is first powered-on, verify that the processor heatsink/fan is turning at a rapid rate.
If the fan is spinning at a slow rate or not spinning at all, power-down the system immediately to avoid any thermal damage.
Important: In single CPU mode, please place CPU on the position of CPU0
________________________________________________________________________
2-14 Hardware Installation