Filter
Top Products
16 CHAPTER 4: SETUP FOR WINDOWS NT
6 When the Select OEM Option window opens, select
FE574B-3Com 10/100 LAN PCCard-Fast Ethernet and
click OK.
7 The Network Adapters list shows a check mark next
to the 3Com LAN card. Click Next to continue.
8 In the Network Protocols list, place a check mark next
to each network protocol required for your site and
click Next.
9 In the Network Services window, place a check mark
in the box next to each desired service. Unless you
are following specific guidelines from your MIS
department, select the default settings.
10 Click Next to install the selected components.
11 When prompted, enter the path to the Windows NT
installation files (for example, D:\i386 on the NT CD)
and click Continue.
When the system prompts again for NT files, click Continue.
12 In the 3Com LAN card dialog box, accept the default
settings and click Continue.
The default settings work in most instances. However, you
may specify network link settings, auto polarity, and IRQ
and I/O values.
13 When the window for enabling or disabling protocols
opens, click Next.
14 When NT is ready to start the network, click Next to
copy the network files.
15 Provide your computer name and workgroup or
domain name when prompted.
16 When the system displays “Networking has been
installed on your computer,” click Finish.
17 When prompted to reboot the computer, remove the
Installation Disk from the floppy drive and click Yes.
If you had Service Pack 3 installed prior to setting up the
LAN card, you should reinstall it now.