Filter
Top Products
3M 1998 3M Multimedia Projector MP8610 1
Safeguards
INTENDED USE
Before operating the machine, please read the entire manual thoroughly. The 3M Multimedia Projector
MP8610 was designed, built and tested for use indoors, using 3M brand lamps, 3M brand ceiling
mount hardware and
nominal local
voltages. The use of other replacement lamps, outdoor operation or
different voltages has not been tested and could damage the projector or peripheral equipment and/or
create a potentially unsafe operating condition.
IMPORTANT SAFEGUARDS
1.
Read and understand all instructions before using. Pay particular attention to areas where this symbol
!
is shown.
!
WARNING
-
Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
!
Caution
-
Indicates a potentially hazardous situation which, if not avoided, could result in
minor or moderate injury. It may also be used to alert against unsafe practices.
9 Note
–
Used to emphasis important conditions or details.
2. Close supervision is necessary when any appliance is used by or near children. Do not leave
appliance unattended while in use.
3. Never look directly into the projector lens when the lamp is on. The metal halide lamp produces a
strong light that could damage your eyesight.
!
4. Care must be taken as burns can occur from touching hot parts.
5. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged - until
it has been examined by a qualified service technician.
!
6. Position the cord so that it will not be tripped over, pulled or contact hot surfaces.
7. If an extension cord is necessary, a cord with an earth/ground and a current rating at least equal to that
of the appliance should be used. Cords rated for less amperage than the appliance may overheat.
8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use.
Grasp plug and pull to disconnect.
9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.
10. To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified
technician when service or repair work is required. Incorrect reassembly can cause electric shock
when the appliance is subsequently used.
11. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire,
electric shock, or injury to persons.
12. Connect this appliance to a grounded outlet.
!
13. This unit is equipped with optical lenses and should not be exposed to direct sunlight.
14. Keep ventilation openings free of any obstructions.
15.
Always operate machine on a flat, sturdy surface.
16.
The projection lamp contains mercury. Always dispose of it in a proper manner according to local
regulations.
17.
To avoid premature lamp failure, do not change the mounting position of the projector (desktop ⇒
ceiling mount or ceiling mount ⇒ desktop mount) and continue to use the same lamp.
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you operate and maintain your 3M MP8610 Multimedia
Projector.
WARNIN
G