Filter
Top Products
© 3M 1999 3M
™
Multimedia Projector MP8740
ENGLISH
3.1 Projector Startup
Section 3: Basic Operations
7
Figure 3.1 Projector Controls
1. Make all cable connections and line hookups with the power off.
2. Turn the POWER SWITCH of the projector on. The ON indicator will light up orange.
3. Move the LENS SHUTTER CONTROL to the open position.
4. Press the STANDBY/ON button . The ON indicator blinks (green) and then lights (green).
The ON indicator will blink green during warm-up and lamp ignition.
5. Adjust the screen size using the ZOOM button .
6. Adjust the focus using the FOCUS button .
A) Press the FOCUS button. The on-screen display shown on the right appears.
B) Adjust the focus so that the picture is sharp using the FOCUS button.
7. Turn on all connected equipment. The method of connecting various equipment, see section 2.3.
8. Press the INPUT button on the projector or the INPUT SELECT (VIDEO or RGB) button on the
remote to select the source of the signal to be projected on the screen. The selected signal input is
displayed at the bottom right of the screen. The display will show the last selected input source before
power was turned off.
ZOOM
FOCUS
CLOSE
OPEN
3.2 Projector Shutdown
1. Hold the STANDBY/ON button for 3-5 seconds. The ON indicator blinks orange and the lamp
turns off. After approximately 1 minute, the fan stops and the indicator stays orange.
2. Turn the MAIN POWER SWITCH of the projector off.
3. Close the LENS SHUTTER . Push up on the lens cover switch to close.
4. Disconnect cables.
Caution
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is
pressed, the fan rotates for about 1 minute to cool the projector.
CLOSE
OPEN
FOCUS
ZOOM
CLOSE
OPEN