Filter
Top Products
3M
™
Personal Projector MP8746/MP8747
12
© 3M IPC 2000
STANDBY/ON
Press STANDBY/ON button to
begin projection mode (lamp on)
or press and hold button for one
second to switch to standby
mode (lamp off).
BLANK
Press to turn ON/OFF the
screen blanking function.
DISK PAD
Press to operate the mouse
shift function and left-click
function.
*AUTO
Press to make projector automatically
adjust 4 items (V. POSIT, H. POSIT, H.
PHASE, and H. SIZE) for RGB input signal.
(Please see note at bottom right.)
MENU
Press to turn ON/OFF the menu
screen display.
MENU directional arrows
Press to select menu items when the
menu screen is displayed.
Press to operate the mouse shift
function.
After the POSITION button has been
pressed, press these buttons to move the
picture upward, downward, and to the left
and right.
*MENU SELECT
Press to display individual menu items.
Can also be used to click the left mouse
function.
*MAGNIFY
Press to magnify the displayed image.
Press (+) to enlarge the center of the
image. Press again to enlarge up to 4x
magnification. Press (-) to reduce display
magnification. (Can also be used with
POSITION to select image area to be
magnified.)
VOLUME and MUTE
Pressing these at the same time will
operate the page-up or page-down
function of the USB mouse.
Section 2: Product Description
VIDEO and RGB
Press to select the input source. Press again
to select the next source.
LASER
Press to turn ON/OFF laser beam pointer.
MOUSE / RIGHT
Press to click the right mouse button.
*POSITION
Press this and any menu directional arrows
for corresponding movement of the picture
(with RGB signal only).
RESET
Press to return a displayed menu item to its
default setting.
Press to click right mouse button.
Press after scrolling with POSITION to return
picture to original position.
*FREEZE
Press to turn ON/OFF the freeze (still) image
display.
VOLUME
Press to adjust loudness of sound.
MUTE
Press to stop audio output. Press again to
resume audio output.
TIMER
Press to turn ON/OFF the Timer on the Menu
screen. (Timer cannot be displayed during
Freeze function.)
*This button will not function if the
messages “NO INPUT IS DETECTED”
or “SYNC IS OUT OF RANGE” are displayed.
Remote Control Transmitter Identification
Figure 2.4 Basic Remote Control Transmitter
Use the remote control transmitter within a distance of approximately 3 meters (or 9.8 feet) from the sensor of
the front of the projector, and within a range of 30° to the left and right. Strong light and obstacles may
interfere with operation of the remote control transmitter.
AUTO ADJUST Notes:
Requires several tens of
seconds.
May not operate correctly in
some cases, depending on
the connected computer and
its signal and type of image.
Execute auto adjust with
display of the running
application set at maximum.
After auto adjust, image may
be slightly darker due to
automatic adjustment of
signal level.
STANDBY/ON
VIDEO
LASER
BLANK
RGB
AUTO
MENU
RESET
POSITION
MENU SELECT
FREEZE
OFF
VOLUME
MAGNIFY
MUTE
TIMER