Filter
Top Products
Opal Pro to Mod TCP
Page 8
Opal Pro Parameter Settings
The parameters in the Opal Pro used to configure the Ehernet interface
card (group 14) are only accessible if a Ethernet interface card is installed.
The parameter settings are as follows:
Opal Pro
Parameter
Setting Description
2.02 Comm Module Ethernet Type of interface card installed
(read only)
10.01 Start/Stop Comm
Module
This allows the Opal Pro to be
started and stopped over the
communication link
10.04 Iref Source Comm
Module
If this is set to Comm Module the
Opal pro will follow the Current
reference from the communication
link. If there is no reference being
sent on the communication link this
should be set to “Internal”
10.05 Phase Angle
Source
Comm
Module
If this is set to Comm Module the
Opal pro will follow the Phase Angle
reference from the communication
link. If there is no reference being
sent on the communication link this
should be set to “Internal”
14.07 Node 1 – 254 This is the Node # of the slave Opal
Pro
14.08 IP Addr 1 0-255 First number in the IP address of
the Opal Pro
14.09 IP Addr 2 0-255 Second number in the IP address of
the Opal Pro
14.10 IP Addr 3 0-255 Third number in the IP address of
the Opal Pro
14.11 IP Addr 4 0-255 Fourth number in the IP address of
the Opal Pro. (the node number as
set in 14.07 is added on to this
number to get the final IP address)
14.12 SubNet 1 0-255 First number in the SubNet Mask
14.13 SubNet 2 0-255 Second number in the SubNet
Mask
14.14 SubNet 3 0-255 Third number in the SubNet Mask
14.15 SubNet 4 0-255 Fourth number in the SubNet Mask