Filter
Top Products
BIOS Setup 3-23
NOTE: To enable this “Power On” function, the wake-up header of [USBPWR1] and [USBPWR2] must
be set to [Enabled] position. Please refer to the configuration of “Wake-up Header” [USBPWR1] and
[USBPWR2] in section 2-4, chapter 2.
The mouse wake up function can only be used with the PS/2 mouse, not with the COM port or USB type.
Some PS/2 mice cannot wake up the system because of compatible problems. If the specs of your
keyboard are too old, it may fail to power on.
KB Power ON Password:
This item sets the password required in order to power on your computer.
NOTE: Do not forget your password, or you will have to clear the CMOS and reset all parameters in
order to utilize this function again.
Hot Key Power ON:
This item powers on the system by pressing <Ctrl> key plus one of each function key (<F1> ~ <F12>)
simultaneously.
User’s Manual