Abit SI7-G Computer Hardware User Manual


 
1-2 Chapter 1
Supports Advanced Configuration Power Interface (ACPI)
Supports Desktop Management Interface (DMI)
AMI BIOS
12. Internal I/O Connectors
1x AGP slot
5x PCI slots
1x Floppy port supports up to 2.88MB
2x Ultra ATA/133/100/66/33 connectors
2x Serial ATA 150 connectors
2x USB headers
2x IEEE 1394 headers
1x CD-IN, 1x AUX-IN header
13. Back Panel I/O
1x PS/2 Keyboard, 1x PS/2 mouse
2x Serial port connectors, 1x Parallel port connector
1x S/PDIF Out connector
AUDIO1 connector (Rear-Left / Rear-Right, Center/Subwoofer)
AUDIO2 connector (Mic-In, Line-In, Front-Left/Front-Right)
2x USB, 1x RJ-45 LAN Connector
14. Miscellaneous
ATX form factor
Hardware Monitoring – including Fan Speed, Voltages, CPU and system temperature
Supports Wake Up by LAN, Modem Ring, RTC Alarm, Keyboard and Mouse Power On
Supports STR (Suspend to RAM)
Onboard debug card design with 7-segment display
15. Order Information
Model Features
SI7 SATA, 10/100M LAN
SI7-G SATA, Gigabit LAN
Supports Wake On LAN, Modem, but your ATX power supply 5V standby power must be able
to provide at least a 720mA current capacity. Otherwise, the functions may not work normally.
This motherboard supports the standard bus speeds of 133/100/66MHz that are used by
specific PCI, processor and chipset specifications. Exceeding these standard bus speeds is not
guaranteed due to the specific component specifications.
The Serial ATA controller only supports Ultra DMA/ATA100 or higher hard drive. Do not use
hard drives under this specification, or it won’t work.
Specifications and information contained herein are subject to change without notice.
SI7 Series