35
... English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
“ ”
When you see this message, change the lamp as soon as pos-
sible.
Make sure the projector has cooled down for at least 30
minutes before changing the lamp.
Warning: Lamp
compartment is hot!
Allow it to cool down
before changing lamp!
Warning: To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power/
Standby button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screw from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
1
3
4
2
1
2
3
4