Filter
Top Products
Fast EtherHub Installation Manual
16
EMI Warning
FCC Class A Certification
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Warning: This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause interference to radio communications.
It has been tested and found to comply with the limits for a Class A
digital device pursuant to Subpart B of Part 15 of FCC Rules, which
are designed to provide reasonable protection against such interference
when operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which
case the user, at his own expense, will be required to take whatever
measures are required to correct the interference.
You may use 100Ω Category 5 unshielded twisted-pair (UTP) or 100Ω
Category 5 shielded twisted-pair (STP) cable for RJ-45 connections.
Warnings
1. Wear an anti-static wrist strap or take other suitable measures to prevent
electrostatic discharge whenever handling this equipment.
2. When connecting this hub to a power outlet, connect the field ground lead on the tri-
pole power plug to a valid earth ground line to prevent electrical hazards.
3. The connectors are not for telephone system use.
Note:
In order to maintain compliance with the limits of a Class A digital device,
Accton requires that you use a quality interface cable when connecting to this
device. Changes or modifications not expressly approved by Accton could
void the user’s authority to operate this equipment. Suggested cable type is:
Twisted-pair for RJ-45 connections: 100BASE-TX