Filter
Top Products
Fast EtherHub Installation Manual
7
HARDWARE INSTALLATION
Quick Installation Procedure
1. Place the hub on a smooth surface or mount it on a rack.
2. Connect power cord to hub and
plug in.
3. Connect workstations to hub
using Category 5 UTP cabling.
? Plug an RJ-45 connector into any port on the hub (other than
the Uplink port), and plug the other end into the RJ-45 port on the
workstation’s Fast Ethernet card. Distance between the hub and
the workstation can be no more than 100 meters.
4. Connect each device (up to 8/12) on your network using the process
described in Step 3.
? Make sure you have the correct wiring
To reliably operate your network at 100Mbps, you must use
Unshielded Twisted-Pair (UTP) Category 5, or better, Data Grade wire.
While Category 3 or 4 wire may initially seem to work, it will soon
cause data loss.