Filter
Top Products
Mapping table of characters used in PPPoE.
Example user name：83721@hinet.net，Password：123ab，The procedure is below
1. Connect the phone to the gateway
2. When CPU/ACT is light, pick up the phone and press
3. ##0000
；You will hear 3 short tones.
4. 0938333732314068696*465742*46*46574#
；Set user name：83721@hinet.net
5. 103132336162#
；Set password is 123ab
6. 981#
；Save and restart.
2. Use Console to configure (Only VG3306/3310/3318)
SIP-RG>enable
SIP-RG#configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#pppoe username 83721@hinet.net
SIP-RG(config)#pppoe password 123ab
SIP-RG(config)#exit
SIP-RG#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes
3. Use WEB Interface to configure:
You can configure the user name and password by using WEB interface. Follow the steps to finish
configuration.
Step 1: Using a traditional phone set to configure the web management password and phone
number
You will need to use a web browser to perform the PPPoE settings through the gateway’s web
based management interface. To enter the web based management interface you must have a
previously configured password. Follow the next procedure to setup your password and phone
number.
1. Connect the gateway to a suitable Power source.
2. Connect a traditional phone set to the “Phone” connector located on the rear panel.
3. When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone.
4. ##0000 ; you should hear three short tones.
5.
15123 ; “123” is the web management password.
16