Filter
Top Products
15. Appendix
15.1. Appendix A: Phone-Set Command
Pick up the handset and listen for the dialing tone. Dial “##0000 and listen for three consecutive
tones before setting the following parameters. After input the parameters, please dial ‘# to end the
configuration.
Command Description
Parameters
01 IP State 0 : static; 1: DHCP; 2: PPPoE
02 IP Address xxx*xxx*xxx*xxx
03 Subnet Mask xxx*xxx*xxx*xxx
04 Default Gateway xxx*xxx*xxx*xxx
05 Primary DNS Server
IP
xxx*xxx*xxx*xxx
06 Second DNS Server
IP
xxx*xxx*xxx*xxx
07 Select Signaling Port 0~65535
08 Select RTP Base Port 0~65534 (limit to even port number only)
09 PPPoE username User name (use the mapping table to map
character into digits)
10 PPPoE password Password (use the mapping table to map
character into digits)
11 DND Do not Disturb, this line accept dial out call only.
All incoming call is terminated. 0 : Disable ; 1:
Enable
12 SIP Forward State 0 : Disable ; 1: Enable; 2: Busy; 3: No Answer
13 SIP Forward To
Number
The SIP number that this line will forward to. The
Forward To address is "key in phone-set
number@SIP proxy registered". For example,
73796@fwd.pulver.com, 73796 is the number
you key-in by phone-set. fwd.pulver.com is the
registered proxy of this gateway.
14 Change Service Port 1:FTP; 2:HTTP 3:Telnet (Port: 0-65535)
15 Change WEB 6 digits
74