Filter
Top Products
VG3300 series user guide
6. 010# ; “0” is to enable “manual” IP mode.
7. 02192*168*0*2# ; IP address.
8. 03255*255*255*0# ; Subnet Mask .
9. 98
1# ; Used to restart the gateway.
10. Hang up the phone to complete the configuration.
Step 2：Configure IP address of PC
Use the provided Ethernet cable to connect your PC to the port labeled “PC”, located on the rear
panel of the gateway. For VG3306, VG3310, and VG3318, it is located on the front panel.
Because the gateway’s default IP setting of this is 192.168.0.2, you must configure your PC to the
same subnet. “192.168.0.x” for example. The following example uses 192.168.0.5 for the IP
address and 255.255.255.0 for the subnet mask.
After you have completed the PC’s IP address setting, you will be required to restart the PC in order
for the new settings to take effect.
Step 3: Using the browser to configure the PPPoE Parameters of the gateway.
17