AccuFitness 4400 Network Cables User Manual


  Open as PDF
of 20
 
support.dell.com Microprocessor Upgrade Installation Guide 1-15
DELL CONFIDENTIAL - Preliminary 9/11/00
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
5HSODFLQJWKH6(&&DUWULGJHDQG+HDW6LQN$VVHPEO\
To install the replacement SEC cartridge and heat sink assembly, perform the follow-
ing steps:
1. Remove the terminator card or old SEC cartridge from the guide bracket
assembly.
2. Slide the SEC cartridge and heat sink assembly into the guide-bracket assembly
until the edge connector on the SEC cartridge is firmly seated in the connector on
the system board (see Figure 1-8).
3. Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the SEC car-
tridge and heat sink assembly in the bracket.
4. Replace the cooling shroud and computer cover.
)LJXUH5HSODFLQJDQ6(&&DUWULGJHDQG+HDW6LQN$VVHPEO\
heat sink
SEC cartridge
retention clips (2)
guide bracket assembly
latches (2)
 previous