Filter
Top Products
Appendix B Notices98
English
EMC Directive 89/336/EEC:
• ETSI EN 301 489-1/17
• ETSI EN 300 328-2
USA - Federal Communications Commission (FCC)
This device complies with Part 15 of FCC Rules. Operation of the devices in an Wireless
LAN System is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired operation.
Exposure to Radio Frequency Radiation
The radiated output power of the Wireless module is far below the FCC radio frequency
exposure limits. Nevertheless, the Wireless module shall be used in such a manner that
the potential for human contact during normal operation is minimized.
The transmitter and the antenna are permanently installed inside the notebook, and are
specific for this model (not for generic computer). The antenna of this device is installed
on the top of the LCD display. For compliance with FCC radiation exposure limits. it
should be operated with a separation distance of 20cm or more between the antenna
and the body of the user, and the antenna should not be operated next to a nearby
person.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment (example - use only shielded interface cables when
connecting to computer or peripheral devices).
As1600_E.book Page 98 Thursday, January 30, 2003 9:51 AM