Filter
Top Products
18 Chapter 2
Integrated Peripherals
Parameter Description Option
IDE Function Setup Press Enter to access the IDE Function Setup submenu.
MCP Storage Config Press Enter to access the MCP Storage Config submenu.
Init Display First Select whether to boot the system using the AGP graphic card or a PCI
card installed on the PCI Express slot or PCI slot.
PCIEx
PCI Slot
Onboard
HD Audio Enables or disables the onboard audio controller. Auto
Disabled
HDMI Audio Allows you to control the audio function of the onboard HDMI. Disabled
Auto
MAC LAN Enables or disables the built-in network interface card. Auto
Disabled
IDE HDD Block Mode When enabled, the BIOS will automatically detect if your hard disk
supports block transfers and set the proper block transfer settings for it.
Depending on the IDE controller, up to 64 KB of data can be transferred
per interrupt when block transfers are enabled.
When disabled, only 512 bytes of data can be transferred per interrupt.
Enabled
Disabled
Onboard Serial Port 1 Select the I/O address and IRQ for the first serial port. 3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Auto
Disabled
Onboard Parallel Port Select the I/O address and IRQ for the onboard parallel port. 378/IRQ7
278/IRQ5
3BC/IRQ7
Disabled
Parallel Port Mode Select an operating mode for the onboard parallel port. SPP
EPP
ECP
ECP+EPP
ECPM Mode Use DMA Select DMA channel for the LPT port in ECP mode. This parameter can
be configured if the parallel port mode is set to ECP or ECP +EPP
mode.
3
1
USB Device Setting Press Enter to access the USB Device Setting submenu.