Filter
Top Products
Chapter 4 53
USB eModule Error Messages
SMBIOS eModule Error Messages
CPU eModule Error Messages
MPS Table (Multi-processor) eModule Error Messages
Message Displayed Description
Warning! Unsupported USB device
found and disabled!
This message is displayed when a non-bootable USB device is
enumerated and disabled by the BIOS.
Warning! Port 60h/64h emulation is
not supported by this USB Host
Controller!
This message is displayed to indicate that port 60h/64h emulation
mode cannot be enabled for this USB host controller. This condition
occurs if USB KBC emulation option is set for non-SMI mode.
Warning! EHCI controller disabled.
It requires 64bit data support in the
BIOS.
This message is displayed to indicate that EHCI controller is disabled
because of incorrect data structure. This condition occur if the USB
host controller needs 64-bit data structure while the USB is ported
with 32-bit data structure.
Message Displayed Description
Not enough space in Runtime area!!. SMBIOS data
will not be available.
This message is displayed when the size of the
SMBIOS data exceeds the available SMBIOS
runtime storage size
Message Displayed Description
Warning! This system board does not support the
power requirements of the installed processor. The
processor will be run at a reduced frequency, which
will impact system performance. area!!. SMBIOS
data will not be available.
This message is displayed when the power
requirements of the board do not match the power
requirement of the CPU.
Message Displayed Description
Insufficient Runtime space for MPS data! System
may operate in PIC or Non-MPS mode.
This message is displayed when there is not enough
space in the 0F000h runtime area for creating MPS
table.