Acer N216 Projector User Manual


 
28
English
User Password
Press to set up or change "User Password".
Use the numerical keys on the remote control to set the
password and press "MENU" to confirm.
To delete the digits, Press .
Enter the password again when you see "Confirm
Password" displayed.
The password should be 4~8 digits in length.
If you select "Request password only after plugging
power cord", you are requested to input the password
every time the power cord is plugged.
If you select "Always request password while projector
turns on", you are requested to input the password every
time the projector is turned on.
Administrator Password
You can enter "Administrator Password" when the "Enter
Administrator Password" or "Enter Password" dialogue box is
displayed.
Press to change "Administrator Password".
The factory default of "Administrator Password" is
"1234".
If you forget your administrator password, do the following
to retrieve the administrator password:
Enter the unique 6-digit "Universal Password" which is
printed on the Security Card that came with your
projector. This unique password will be accepted by the
projector no matter what the administrator password is.
If the Security Card is lost, please contact your local Acer
service center.
Lock User Startup Screen
The default value is "Off". If it is "On", you cannot
change the startup screen arbitrarily.
VGA OUT
Selecting "On" enables the function. The projector can output
a VGA signal when it is in standby mode and the VGA IN (or
VGA IN 1) and VGA OUT sockets are correctly connected to the
devices.
Enabling this function slightly increases the standby
power consumption.