Acer XD1270 Projector User Manual


  Open as PDF
of 47
 
37
... English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you
a warning message “Lamp is approaching the end of its useful
life in full power operation. Replacement Suggested!” When
youseethismessage,changingthelampassoonaspossible.
Makesuretheprojectorhasbeencooleddownforatleast30
minutes before changing the lamp.
Warning:
Lamp compart
-
ment is hot! Allow
it to cool down
before changing
lamp!
Warning:
To
reduce the risk of
personalinjury,do
not drop the lamp
module or touch
the lamp bulb. The
bulb may shatter
and cause injury if
it is dropped.
1
3
2
Lamp Changing Procedure:
1.TurnthepowerofftheprojectorbypressingthePower
button.
2. Allowtheprojectortocooldownatleast30minutes.
3. Disconnect the power cord.
4. Useascrewdrivertoremovethescrewfromthecover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7.Pulloutthelampmodule.
To replace the lamp module, reverse the previous steps.
4
 previous next