Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7130
1U Rackmount System
Installing the Server into a Telco Rack
To install the server into a Telco type rack, use two L-shaped brackets on either side of the chassis (four
total). First, determine how far the server will extend out the front of the rack. Larger chassis should be
positioned to balance the weight between front and back. If a bezel is included on your server, remove it.
Then attach the two front brackets to each side of the chassis, then the two rear brackets positioned with
just enough space to accommodate the width of the rack. Finish by sliding the chassis into the rack and
tightening the brackets to the rack. See Figure 2-5.