Filter
Top Products
1010
1010
10
With the printer in the setup menu and with
CONFIGURE [NEXT/OK] CONFIGURE [NEXT/OK]
CONFIGURE [NEXT/OK] CONFIGURE [NEXT/OK]
CONFIGURE [NEXT/OK] as the last item printed, press
OK OK
OK OK
OK (right side) to access the
CONFIGURE CONFIGURE
CONFIGURE CONFIGURE
CONFIGURE menu. The
following is printed:
LL
LL
L
OAD DEFOAD DEF
OAD DEFOAD DEF
OAD DEF
AULAUL
AULAUL
AUL
TSTS
TSTS
TS gives you the opportunity to reset the
printer to all default settings (shown below).
Choose
OK OK
OK OK
OK to do this or
NEXT NEXT
NEXT NEXT
NEXT to go to the next param-
eter. The following is printed:
Baud rate is the next parameter you can set in the
CONFIGURE CONFIGURE
CONFIGURE CONFIGURE
CONFIGURE menu. The complete list of parameters and
their possible values is shown below.
The sample list above shows the current baud rate is
2400. To accept this, press
OK OK
OK OK
OK (right side) or view the
next baud rate value by pressing
NEXT NEXT
NEXT NEXT
NEXT (left side). Press
OK when the baud rate you want is displayed
.
Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200
DD
DD
D
AA
AA
A
TT
TT
T
A BITSA BITS
A BITSA BITS
A BITS is the next parameter. Choose the data bit
value the same way baud rate was chosen. Choices are 7
or 8 data bits.
Baud RateBaud Rate
Baud RateBaud Rate
Baud Rate
Data BitsData Bits
Data BitsData Bits
Data Bits
Load DefaultsLoad Defaults
Load DefaultsLoad Defaults
Load Defaults
The complete list
of defaults is
shown in the
Default Table at the
end of this manual.