Filter
Top Products
Appendix D: Using the Adaptec Flash Utility for DOS ● 86
5 Update the flash using the instructions suitable for your requirements:
● To update a single HostRAID controller:
AFU UPDATE /C <
cont_number
>
Where <cont_number> is the number of the RAID controller whose firmware you
are updating. For example, to upgrade Controller 0, type
AFU UPDATE /C 0
● To update multiple HostRAID controllers:
AFU UPDATE /C <
cont_number_a
>,<
cont_number_b
>
Where <controller_number_a> and <controller_number_b> are the
numbers of the Adaptec RAID controllers whose firmware you are updating. For
example, to upgrade controllers 0, 2, and 3, type
AFU UPDATE /C 0, 2, 3.
●
To update all HostRAID controllers simultaneously
:
AFU UPDATE /C all
Note: The UFI file identifies the RAID controllers, so you don’t have to worry about flashing
the wrong controller.
6
When prompted, insert the first firmware disk into your floppy disk drive.
The AFU reads the first disk.
7 When prompted, remove the first firmware disk and insert the second firmware disk into
your floppy disk drive.
8 Repeat Step 7 until the flash update is complete.