Filter
Top Products
6
Connecting Your ATA Disk Drives
Connecting Your ATA Disk Drives
The ASH-1233 adapter supports up to four ATA disk drives in a
master/slave configuration. (See Setting Jumpers on ATA Disk Drives
on page 5 for more information.)
Connect each ATA disk drive to the ASH-1233 adapter using the
proper 40-pin IDE cable.
Note:
The Adaptec ASH-1233 adapter does not support Cable
Select (CSEL) settings
. You must change the jumper settings
to set drives as master or slave.
To connect your ATA disk drives, follow the instructions for your
specific drive configuration:
■ To install an ATA disk drive as the only device on a cable, see
page 7.
■ To install two ATA disk drives on the same cable, see page 8.
Connector (to Master)Connector (to Slave)
C
onnector (to Adapter)