Filter
Top Products
9
Installing the Device Driver
2 Connect an LED cable from your computer’s motherboard to
the primary LED connector on your ASH-1233 adapter (shown
in the Figure on page 2).
3 Connect a power cable from your computer’s power supply to
each ATA disk drive.
4 Close your computer cabinet, reattach the power cord, then
power on your computer.
Continue with Installing the Device Driver on page 9.
Installing the Device Driver
Before you can begin using your ASH-1233 adapter and ATA
drives, you must install the device driver.
Follow the instructions provided for your operating system:
■ For Windows XP, see page 10.
■ For Windows 2000, see page 12.
■ For Windows Me, see page 15.
■ For Windows 98SE, see page 17.
Note: If you are installing your ASH-1233 adapter and ATA
drives as part of a fresh operating system installation, refer to
the Readme file on the CD for instructions.