Adaptec ATA II 1430SA Network Card User Manual


 
Glossary 89
build
Background initialization of a redundant array. The array is accessible throughout. RAID 1 copies the
contents of the primary drive to a secondary drive. See clear.
bus
See channel.
C
cache
Fast-access memory on the controller that serves as intermediate storage for data that is read from, or
written to, drives.
capacity
Total usable space available in megabytes or gigabytes.
channel
Any path, or bus, used for the transfer of data and the control of information between storage devices and a
RAID controller. For SATA channels, each channel has a single drive capacity.
check point
A feature that enables you to exit the ACU when an operation is in progress and be able to continue without
interruption. The driver then resumes the operation from where the BIOS left off and the BIOS resumes the
operation where the driver left off.
chunk
See stripe.
clear
Foreground initialization of a fault-tolerant array. A clear operation zeros all blocks of the array. The array
is not accessible until the clear task is complete.
concatenation
Joining of physical or logical drives in sequential order.
configure
Process of preparing a disk for use by the controller. When a disk is configured, the controller records the
RAID signature on the disk.
configured array
An array that is ready for data reads and writes. Arrays can be configured by build or clear.
consistency check command
Command that reads all the blocks of a RAID 1 to determine if the blocks are consistent. Any inconsistent
blocks are fixed.
D
dead partition
See failed.
degraded
A redundant (for example, a RAID 1) array in which one or more members have failed. The data is intact
but redundancy has been compromised. Any further failure would cause the array to fail and result in data
loss.
disk
Physical disk drive. Randomly accessible, rewriteable data storage device. Also called hard disk.