ADC 600F Network Card User Manual


 
Selecting Configuration Parameters
52 Megabit Modem 400F, 500L, 600F, and 700F User Manual
SELECTING CONFIGURATION PARAMETERS
There are many configuration options for the modem from which you can select. The following
options are recommended for enhanced performance.
DHCP to allow the modem to dynamically serve IP addresses to devices on the LAN
NAT to map public IP addresses (proxy IP addresses) acquired from the service provider
for the WAN sessions to private IP addresses on the LAN
The following table shows possible configurations, with the recommended configuration first:
SETTING UP THE PPP MODE (700F ONLY)
For the Megabit Modem 700F only, you can select either PPP over ATM or RFC 1483
bridge/router encapsulation for all sessions you set up. To have all sessions (up to 32) as PPP
over ATM mode of operation, do the following:
1
From the system menu, select
general.
2 Select
PPP Over ATM as the Mode
of Operation
.
3 Click
Apply, then reset the
modem.
DHCP NAT How IP Address Acquired
On On Dynamic
Off On Dynamic
On On Fixed
Off On Fixed
Off Off Fixed