Adder Technology SmartView Switch User Manual


 
SmartView Installation and Use Page 28
names. The On Screen Menu is recommended for selecting computers on cascaded
SmartViews as this avoids the need to use long hotkey sequences that may be hard
to remember. When using the On Screen Menu, limit the cascade depth to three
levels (the maximum number of port digits that can be added to the menu).
For example, consider a situation where two SmartView Pro units are connected
together as shown below. To connect to the computer attached to port 3 on
SmartView B the user would hold down the hotkey keys then press ‘2’ followed by
‘3’, whilst keeping the hotkey keys pressed. This will have the effect of connecting to
port ‘3’ of the SmartView which is connected into port ‘2’ of the first SmartView unit
A. (note: if you are cascading 12 and 16 port units then you will need to type a
leading 0 before all single digit port numbers).
For example to connect to port 3 on the SmartView SV8PRO cascaded off port 2 of
your first SmartView SV8PRO use:
press
baba
22release 2
press 33release 3
ba
For example to connect to port 14 on the SmartView SV16PRO cascaded off port 1
of your first SmartView SV16PRO use:
press
baba
00release 0
press 11release 1
press 11release 1
press 44release 4
ba