Filter
Top Products
SmartView Installation and Use Page 23
‘HOTKEYs’ and ‘9’ - selects channel 9 (12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 0’ - selects channel 10 (12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 1’ - selects channel 11 (12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 2’ - selects channel 12 (12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 3’ - selects channel 13 (16 port models only)
‘HOTKEYs’ and ‘1 then 4’ - selects channel 14 (16 port models only)
‘HOTKEYs’ and ‘1 then 5’ - selects channel 15 (16 port models only)
‘HOTKEYs’ and ‘1 then 6’ - selects channel 16 (16 port models only)
‘HOTKEYs’ and ‘TAB’ - selects the next channel
‘HOTKEYs’ and ‘M’ - displays the on screen menu for selecting computers by name
‘HOTKEYs’ and ‘A’ - selects autoscan mode where each channel is displayed for
the selected time (see section 4.3). To cancel autoscan mode simply select any
fixed channel either by hotkey or using the SmartView button.
‘HOTKEYs’ and ‘0’ – switches off the video signal and displays 0. This will cause
some monitors to go into standby mode or switch off. The video signal can be re-
enabled by selecting a channel.
‘HOTKEYs’ and ‘L’ - disables the SmartView's shared keyboard and mouse and
displays 0. The video signal is switched off. If a password has not been set then the
SmartView can be re-enabled by selecting a channel. If a password has been set
then the SmartView displays 'P' to indicate that a valid password must be entered to
unlock the switch. Simply type the same key combination as was set during
configuration (see section 4.8) followed by the (enter) key. Note - if anyone has
typed at the keyboard whilst in secure mode, it will be necessary to type (enter) first
to clear the invalid password, then type the valid password followed by (enter) again.
‘HOTKEYs’ and ‘0 then {number}’ – (where {number} is 0,1,2,3,4,5,6,7,8 or 9).
Selects the channel specified by {number}. This allows ports on cascaded units to be
selected. For example HOTKEYs + 0 10216 would select port 1 (01) on the current
SmartView, port 2 (02) on the next cascaded SmartView and port 16 on the last
SmartView.