Filter
Top Products
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Unpacking and Overview
Refers to Device 1 - 5
LED will light up. If the drive is being accessed, the green LED will blink.
This is where you connect your eSATA devices (like your eSATA
Drive Activity LED:
eSATA Ports:
drive enclosure)
D1 – D5:
Power input: Connects to 5V Power supply or USB power cable.
Power on/off: This turns the port multiplier ON or OFF. When the power switch
is in the OFF position, the port multiplier will be powered by a USB host, if
connected. When the power switch is in the ON position, the port multiplier will
be powered by the power input.
eSATA Host: Connects to eSATA controller card on a computer.
USB 3.0 Host: Connects to USB 2.0 or 3.0 port on a computer.
NOTE: Do not connect USB and eSATA at the same time.
Host LED: Glows to indicate an active connection from USB or eSATA to a host
adapter, blinks to indicate activity.
Dipswitch and SET Button: Used to control the Port Multiplier RAID Mode
setting.
eSATA Device Port
Dipswitch (SW1)
Power
input
Power
on/off
USB 3.0
to host
eSATA
Host
Host
LED
Power LED
SET
Button
Power Supply
USB Power Cable Driver Disk