Filter
Top Products
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Compatibility
Duplicator is USB 2.0 compliant. Works with USB 3.0 devices at 480Mb/s.
Works with the following devices:
- USB Flash media drive
- USB External hard disk
- Addonics Pocket Ultra DigiDrive (including PCMCIA storage devices or
flash
storage with the Addonics adapters)
- Addonics Pocket eSATA/USB DigiDrive
- Addonics Pocket Micro SATA UDD
- Addonics Diamond or Ruby ExDrive, with or without Cipher feature, using
the Addonics USB 3.0 to eSATAp Adapter
- Any of the above USB storage devices used with the Addonics CipherUSB
NOTE: Using an external power supply with storage devices that support
external power is strongly recommended.
Using the Duplicator with Adapters not supplied by Addonics is not
supported or recommended.
Duplicating source media encrypted using the Addonics Cipher family of
products can be done without using the Cipher hardware – which will result
in encrypted duplicates. This requires the Setup option Copy Area to be set
to “Whole Media.”
The Duplicator can copy media formatted as FAT16, FAT32, NTFS, ext2 or
ext3 with the Setup option Copy Area set to “System and Files.” Copying
NTFS media this way requires target media that is larger in capacity than the
source.
Quick Start
1. Insert the source device into the source slot, and any target devices
desired.
2. Turn on the unit.
3. After a self-diagnostic, the unit will scan all ports and start on the Copy
function.
4. Press OK to begin.
5. The Duplicator can operate in Asynchronous mode if it is able to contain
all of the source data in internal memory – about 200MB. Otherwise it will
operate in Direct mode.