Filter
Top Products
www.addonics.com
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/
CONTACT US
7.6. Asynchronous
Enables or disables Asynchronous Mode during the copy function. When
enabled, the Copy, Compare, and Copy+Compare functions will work as
described by the Quick Start section of this User Guide. When disabled,
the Copy, Compare, and Copy+Compare functions will work as described
in the Quick Start section of this User Guide in Direct Mode only.
Default is “Enable.”
7.7. Check Before Copy
Enables or disables testing target media before proceeding with the Copy
function.
Default is “Do Check” (enabled).
7.8. Power Off Time Between Copy+Compare
Determines the delay in seconds between the Copy and Compare func-
tions during Main Menu function 3. Copy+Compare.
Default is 3 (seconds).
7.9. Language
Sets the language used by the firmware's LCD display. Choices are
English or Japanese.
Default is English.
7.10. Working Mode
Determines the approximate rate at which the Duplicator will attempt to
copy media. Faster settings may shorten copy time but result in higher
failure rates, slower settings will cause the process to take longer but will
improve the reliability of the copy.
Default is “Normal Mode.” Choices are: Slowest, Slower, Normal, Faster,
Fastest.
7.11. Set HDD Mode
When enabled, all target devices will be required to be equal to or greater
than the capacity of the source, overriding “LOW Limit” tolerance settings
(see 7.5. Target Tolerance).
7.12. Restore Default
Returns all settings to their factory default values.