Filter
Top Products
MP-11x & Microsoft Office Communications Server 2007
Quick Installation Guide 14 Document #: LTRT-26301
3.2 Assigning an IP Address to the MediaPack
If the gateway's default IP address (refer to Table 3-1) doesn't correspond to the network in which
Office Communications Server 2007 is installed, you can assign a different IP address to the
gateway, using one of the following methods:
BootP (refer to Section 3.2.1 on page 14)
Command Line Interface (CLI) using the RS-232 interface (refer to Section 3.2.2 on page 15)
Gateway's HTTP-based Embedded Web Server (refer to Section 3.2.3 on page 16)
DHCP (refer to the gateway's User’s Manual)
Table 3-1: Gateway Default Networking Parameters
Network Parameter Default Value
IP address 10.1.10.11
Default subnet mask 255.255.0.0
Default gateway IP address 0.0.0.0
You can use the hardware reset button to restore the gateway's networking parameters to their
factory default values (refer to Section 6.2 on page 40).
3.2.1 Assigning an IP Address using BootP
You can use AudioCodes' Bootstrap Protocol (BootP) or any third-party BootP application to
assign an IP address to the gateway.
¾ To assign an IP address using BootP, take these 3 steps:
1. Open the BootP application.
2. Add a new client by performing the following (for AudioCodes BootP Server application):
a. From the Services menu, choose Clients; the Client Configuration dialog box appears.
b. Add a client configuration for the gateway that you want to initialize, by clicking the Add
New Client
button.
c. Enter the necessary fields (i.e., gateway's MAC address and desired IP address), and
then click OK.