Filter
Top Products
18
IPPC-9120/9150 Series User's Manual
2.4 Installing a 2.5" HDD
The system supports one 2.5" slim type IDE HDD. The IDE controller, which
uses a PCI local bus interface, allows the HDD to exceed 528 MB.
When installing an HDD, follow these steps:
1. Unlock the back door and open it.
2. Unscrew the bolt in the center of the HDD-FDD bracket.
3. Detach the FDD flat cable.
4. Remove the five screws on the back case (see Fig. 2-5).
5. Take out the HDD-FDD bracket.
6. Remove the four screws in the bottom of the HDD-FDD bracket (see Fig.
2-6).
7. There are two HDD support assemblies. Unscrew the two screws on the
side of each HDD support assembly.
8. Mount the HDD support assemblies, one on each side of the HDD.
9. Fasten the four screws in the bottom of the HDD-FDD bracket (see Fig. 2-
6).
10. Put in the HDD-FDD bracket.
11. Fasten the five screws on the back case (see Fig. 2-5).
12. Attach the FDD flat cable.
13. Fasten the bolt in the center of the HDD-FDD bracket.
14. Close the back door and lock it.