Advantech IPPC-9120 Laptop User Manual


 
Chapter 2 System Setup
21
Figure 2-7: Assembling the HDD
2.5 Installing a CD-ROM Drive
One slim type CD-ROM drive can be installed in the system. Before installing
the CD-ROM drive, take out the FDD-HDD bay. (Refer to Section 2.4)
1. Remove the three screws on the bottom of back case (see Fig. 2-8).
2. Pull out the drive bay cage, and attach the CD-ROM drive's cable to
connector CN18 on the motherboard.
3. Install "CDR-9150-24X" into the drive bay by inserting it directly into the
end. Then attach the cable to the CD-ROM drive.
4. The securing ("fix") clip is located on back of the CDR-9150-24X. Move
the short arm of the clip so that the lug at its end engages into the hole in
the long arm of the clip. Then press the connector tightly onto the CD-
ROM. (See Fig. 2-9.)