Filter
Top Products
MIC-3043 User Manual 10
2. Make sure that the handles of the card are not latched. Release the
handles if they are latched. Handles from different vendors may
have different latch designs.
3. Insert the card into the chassis by sliding the upper and lower edges
of the card into the card guides.
4. Push the card into the slot gently by sliding the card along the card
guide until the handles meet the rectangular holes of the cross rails.
Figure 2.3: Installing a card into the chassis
5. Pull the upper handle down and lift the lower handle up to push the
card into place.
6. Secure the card by locking the handles into place.
Caution!!!
Keep your fingers away from the latch hinges
to prevent your fingers from getting pinched.
Note: If the card is correctly positioned and has been
slid all the way into the chassis, the handles
should match the rectangular holes. If not,
remove the card from the card guide and
repeat step 3 again. Do not try to install a card
by forcing it into the chassis.