Filter
Top Products
POC-195 User Manual 12
2.2 Installation Procedures
2.2.1 Connecting the power cord
Be sure to always handle the power cords by holding the plug ends only.
Follow these steps to connect the power cord:
1. Connect the female end of the power cord to the AC inlet of the
panel PC.
2. Connect the 3-pin male plug of the power cord to an electrical out-
let.
Figure 2.4: Connecting the power cord
2.2.2 Connecting the keyboard and mouse
1. Connect the Y-shaped adapter to the PS/2 mouse and keyboard port
on the I/O section of the POC-195.
2. Connect the PS/2 mouse and keyboard to the Y-shaped adapter.
If you use a serial mouse, you can connect the mouse to any COM port in
the I/O section.
2.2.3 Switching on the power
Press the power switch on the front of the PC.