AGFA Scanner Scanner User Manual


 
Chapter 2 — Installing the scanner 16
Installation for the Apple Macintosh
This section shows you how to set up your SnapScan with your Macintosh computer. You must first
choose and set a SCSI ID number, then connect the scanner to your Macintosh, and finally test the
connection.
Choosing a SCSI ID number
Connecting the scanner
Testing the connection
Choosing a SCSI ID number
Before you connect your SnapScan to your Macintosh, you have to find out which SCSI ID numbers
are already assigned and which numbers are free. To do this, you can use the Macintosh utility
‘SCSI ID Checker’. You will find this utility in the FotoLook or FotoSnap folder at the top level of
your start-up disk after you installed the software. You will find the instructions for installation of the
software on the CD-ROM leaflet.
1. Make sure that your scanner is disconnected.
2. Open the SCSI ID Checker.
A dialog box appears with a list of the SCSI ID numbers that are free in your Macintosh
computer.