Filter
Top Products
Chapter 2 — Installing the scanner 26
Connecting the scanner
Before you connect the scanner to your PC, make sure that your scanner as well as your PC and
everything connected to it are switched off.
A SCSI cable is supplied with your scanner.
Caution: For safety reasons, never use extension cables for power cables.
Always make sure there are no more than two terminators in your SCSI chain, one at the beginning and one at
the end. Some SCSI devices have built-in terminators and must therefore be placed at the beginning or end of
your SCSI chain. Please check the documentation of each of your SCSI devices if you are not sure whether
the device has a built-in terminator. The last device in your chain has to be terminated. Your SnapScan has no
built-in terminator.
Never try to connect the scanner to the serial or parallel port of your PC: you might seriously damage your
equipment if you do.
■ If your PC has a high density SCSI connector, you might need to buy a special cable from your
dealer.
■ If your PC has a 25-pin connector, follow the instructions of “Installation for the Apple
Macintosh': 'Connecting the scanner”.