Agilent Technologies 34970-80010 Webcam User Manual


 
4 Install the internal DMM circuit board into the chassis.
Position the internal
DMM circuit board inside the instrument chassis
by tilting it at an angle as shown below. Be sure to position the circuit
board over the tabs in the chassis as shown. Then, lower the assembly
into the chassis until it is parallel with the 34970A circuit board.
5 Lock the internal DMM circuit board in place.
Slide the internal
DMM circuit board to the left (toward the rear of the
instrument) until it locks in place. You will hear a click when it is
properly locked in place.
Make sure that shield is locked
in place behind this tab
2