Filter
Top Products
Installing Uplink and Stacking Modules OmniSwitch 6600 Series Chassis and Hardware Components
page 2-30 OmniSwitch 6600 Series Hardware Users Guide April 2004
3 Slide the module back until the backplane connector is inserted in the chassis backplane; the module’s
front panel should be flush with the front of the chassis. Do not force the module into the slot. Otherwise
you can damage the connectors.
4 Once the module is firmly seated and flush with the chassis front panel, secure the module by tighten-
ing the two captive screws. Be sure not to overtighten the captive screws. If you use a screwdriver, the
torque used to tighten the screws must not exceed 2.3 inch pounds.
Tightening the Captive Screws
EXPANSION/STACKING
51
52
LINK/ACT
LINK/ACT