Filter
Top Products
www.aleratec.com
46
Specications
Power Requirements 115 - 230 VAC Switchable
Dimensions
(depth x width x height)
D: 393.7mm W: 177.8mm H: 266.7mm
(7” x 10.5” x 15.5”)
Weight 12.8 Kilograms (28 Lbs.)
Note: Specifications subject to change without notice.
Troubleshooting
If your 1:5 HDD Cruiser is not performing as expected, refer to the symptoms
below, and follow the suggested corrective action.
Symptoms Corrective Actions
LCD Display If the LCD display does not display any message and the
backlight is not lit after powering on the 1:5 HDD Cruiser,
check that the power cable is properly connected and that
the ON/OFF switch is turned on.
Error Messages While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the 1:5 HDD Cruiser to stop
responding. If this happens, power the unit off, wait about
ten (10) seconds, and then reapply power.
Hard Disk If the 1:5 HDD Cruiser does not detect one of the hard
disk drives, verify that the drive is properly seated in the
drive bay.
Keypad Buttons If pressing the keys on the front panel produces no
response from the system, the 1:5 HDD Cruiser may still
be busy with the previous operation. If the system idle,
power the unit off, wait about ten (10) seconds, and then
reapply power.
Firmware Update The device can be updated to new versions of rmware
via a DVD/CD drive. If unable to update the rmware,
check that the rmware was downloaded correctly. A
failed rmware upgrade may cause the 1:5 HDD Cruiser
to become inoperable. If the system is working normally,
do not attempt this operation. If the system is already
experiencing problems, please contact Aleratec for repairs.
Startup/Shutdown Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.